Rockspace Extender Showing Red Light After Setup: Fixed

So you are getting a solid red light on your Rockspace range extender after you have set up your device to your home network. We understand that this can be very annoying. A red light on your Rockspace range device can be due to improper or impartial Rockspace extender setup process. If you have not followed the right procedure to set your extender up, then you will not be able to access its network too. To get this issue fixed, you will need to verify a few things and you will have to perform some troubleshooting steps as mentioned ahead.

Troubleshooting Red Light on Rockspace Extender After Setup

If you encounter a red light issue on your Rockspace range extender post setup process, here is what you need to do to do away with it.

Step 1: Check Extender to Router Distance

You need to be assured that your Rockspace range repeater is in the range of the router. Maintain a proper distance between the devices. If the distance is more, then the extender would not be able to receive the router’s signal. However, if the distance is less, there will be a lot of interference between them. Make certain you maintain an appropriate distance between the two.

Step 2: Verify Network Password

Check that you are entering the correct password to try to access the router network. Double-check the password by getting on to the router management console.

Step 3: Disable Security Settings

Verify that any security settings like MAC filtering, access control, etc. are not enabled on your router. If any such settings are enabled then this will not allow your Rockspace extender to access the router network. Disabling any such setting will be the best choice.

Step 4: Reboot Rockspace Extender

Any minor technical glitches get easily fixed by rebooting the device. Detach all the cables from the extender after turning off the repeater power. Attach the cables back after waiting for some time. Turn on the power supply. If this does not fix the issue, move to a further step without wasting any minutes.

Step 5: Reset Rockspace Extender

Locate the Reset button on your Rockspace range repeater and press it. This will reset your extender to the factory settings, thereby deleting all the personalized data on it. The good news is that along with data deletion, any technical errors will also get deleted from the extender.

Step 6: Reconfigure the Extender

After resetting, reconfigure your Rockspace extender from scratch. To reconfigure the repeater, follow the below-given process:

Securely connect your Rockspace repeater to the router using an Ethernet cable.
Power on the extender. Wait till the LED lights on it are stable.
Launch your preferred web browser on your computer.
In the address bar, type re.rockspace.local and also press the Enter key.
You will land on the Rockspace device login window.
Enter the default username and password.
Click on Log In button.
Once you get on the Rockspace extender setup page, follow the instructions that you also see on the screen to complete the setup or configuration process.

Final Note

We are very hopeful that by following the above-mentioned steps, the light on your Rockspace wireless range device will turn solid green from red. We recommend you to upgrade your extender firmware to the latest version for smooth functionality of your device. Firmware update will enhance the overall performance of your Rockspace wifi range extender. This will also add new features as well as make security improvisations to it. To update the firmware on your Rockspace range extender, do the re.rockspace.local login to access your extender settings. Here, you can easily update the latest version of firmware on your device.